Default Network Threat Protection task settings

Support

Support for business applications

Kaspersky Industrial CyberSecurity for Nodes

Network Threat Protection

Default Network Threat Protection task settings

3 August 2023

ID 194402

The Network Threat Protection task uses the default settings described in the table below. You can change the values of these settings.

Default Network Threat Protection task settings

Setting	Default value	Description
Processing mode	Only inform about network attacks	The Network Threat Protection task can be started in Pass-through, Only inform about network attacks or Block connections when attack is detected mode. The check box enables or disables adding hosts showing activity typical of network attacks to the list of blocked hosts. If this mode is selected, Kaspersky Industrial CyberSecurity for Nodes scans inbound network traffic for activity that is typical of network attacks, logs events about detected activity, and adds IP addresses of hosts showing activity typical of network attacks to the list of blocked hosts. You can view the list of blocked hosts in the Blocked Hosts storage. You can restore access to blocked hosts, and specify the number of days, hours, and minutes after which hosts regain access to network file resources after being blocked by configuring the Blocked Hosts storage settings. If this mode is selected, Kaspersky Industrial CyberSecurity for Nodes scans inbound network traffic for activity that is typical of network attacks, logs events about detected activity, but doesn't block network activity from the attacking computer. The mode is selected by default. If this mode is selected, Kaspersky Industrial CyberSecurity for Nodes scans inbound network traffic for activity that is typical of network attacks, but doesn't log events about detected activity and doesn't block network activity from the attacking computer. For example, you can use this mode in case of a decrease in the protected device's performance.
Exclusions	The exclusion list is not applied.	Specify areas that you want to exclude from the task protection scope.
Schedule settings	By default, the Network Threat Protection task starts automatically when Kaspersky Industrial CyberSecurity for Nodes starts.	You can configure the schedule.

Did you find this article helpful?

What can we do better?

Thank you for your feedback! You're helping us improve.