Viewing the topology of a deployed SD-WAN instance

You can view the topology of a deployed SD-WAN instance. The topology displays tunnels and segments between CPE devices, as well as the paths within the segments.

To view the topology of a deployed SD-WAN instance:

1. In the menu, go to the Infrastructure section.

   This opens the resource management page. By default, the Network resources tab is selected, which displays the table of SD-WAN and SDN Controllers.

2. Click Management → Configuration menu next to the Controller deployed for the SD-WAN instance.

   This opens the Controller configuration menu. By default, you are taken to the Controller nodes section, which displays a table of Controller nodes.

3. Go to the Topology section.

   The topology of the SD-WAN instance is displayed.

4. If necessary, select the following check boxes:
   • Select the Tunnel utilization check box to display the utilization of the tunnels. The utilization level of the tunnel is represented by the following colors:
     • Green — Low tunnel utilization.
     • Yellow — Medium tunnel utilization.
     • Red — High tunnel utilization.
   • Select the Segments check box and in the Segment switches drop-down list, select two CPE devices to display all tunnels between those devices.
   • Select the Name check box to display the names of CPE devices.
   • Select the IP address check box to display the IP addresses of CPE devices.

   By default, all check boxes are cleared.