Adding or deleting a static route

In addition to dynamic route exchange between CPE devices and external network devices via BGP and OSPF protocols, Kaspersky SD-WAN supports static IPv4 routes.

Adding a static route

You can add a static route in a CPE template or on an device. When you add a static route to a CPE template, the static route is automatically added on all devices that are using the template.

To add a static route:

1. Add a static route in one of the following ways:
   • If you want to add a static route in a CPE template, go to the SD-WAN → CPE templates menu section, click the template and in the displayed settings area, select the Static routes tab.
   • If you want to add a static route on a CPE device, go to the SD-WAN → CPE menu section, click the device, and in the displayed settings area, select the Static routes tab and select the Override check box.

   A table of static routes is displayed.

2. Click the add static route icon .
3. In the Interface drop-down list, select the previously created source network interface of the static route.
4. In the Target field, enter the destination IPv4 address of the static route.
5. If necessary, in the IPv4 netmask field, enter the IPv4 address of the destination subnet of the static route.
6. In the Gateway field, enter the IP address of the gateway of the static route.
7. In the Metric field, enter a metric for the static route. The default setting is 0.
8. In the MTU field, enter the MTU value for the static route.
9. In the Type drop-down list, select the type of the static route:
   • unicast (default)
   • local
   • broadcast
   • multicast
   • unreachable
   • prohibit
   • blackhole
   • anycast
10. If you want to put a static route in a virtual routing and forwarding table, in the VRF drop-down list, select a previously created virtual routing and forwarding table. You must place the static route in the virtual routing table that contains the network interface of the source of the static route.

    The static route is added and displayed in the table.

11. In the upper part of the settings area, click Save to save the settings of the CPE template or device.

Deleting a static route

You can delete a static route in a CPE template or on an device. When you delete a static route in a CPE template, the static route is automatically deleted on all devices that are using the template.

Deleted static routes cannot be restored.

To delete a static route:

1. Delete a static route in one of the following ways:
   • If you want to delete a static route in a CPE template, go to the SD-WAN → CPE templates menu section, click the template and in the displayed settings area, select the Static routes tab.
   • If you want to delete a static route on a CPE device, go to the SD-WAN → CPE menu section, click the device, and in the displayed settings area, select the Static routes tab and select the Override check box.

   A table of static routes is displayed.

2. Click the delete icon next to the static route that you want to delete.

   The static route is deleted and is no longer displayed in the table.

3. In the upper part of the settings area, click Save to save the settings of the CPE template or device.