Starting automatic configuration of the application

3 July 2024

ID 173971

If you are using Debian or Ubuntu in a language other than English, you must change the language of the operating system prior to starting initial configuration of the application.

To start automatic configuration of the application, run the following command:

/opt/kaspersky/kwts/bin/setup.py --auto-install=<full path to the automatic configuration file>

The settings of the automatic configuration file for the application are listed in the table below.

Settings of the automatic configuration file for the application

Parameter

Description

Available values

eula

Acceptance of the terms of the License agreement.

yes

privacy_policy

Acceptance of the terms of the Privacy Policy.

yes

default_protection_settings

Consent to set the default protection settings.

yes

nodeip

Selection of the IP address of the network interface used for interaction with other nodes of the cluster.

<IP address in either IPv4 or IPv6 format>

nodeport

Selection of the port used for interaction with other nodes of the cluster.

It is recommended to use the default value of 9045.

<port>

adminpassword

Entry of the local administrator password.

<password that meets the requirements>

Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.