Configuring date and time

3 July 2024

ID 204546

You can configure the server time used in application settings. Database updates and message processing rules for which the schedule is defined will be applied based on the set time.

To configure the time on the server:

  1. In the application web interface, select the SettingsGeneralDate and time section.
  2. In the Time zone settings group:
    1. In the Country drop-down list, select the country of the necessary time zone.
    2. In the Time zone drop-down list, select the time zone.
  3. In the Time synchronization settings group, use the Synchronize with NTP server toggle switch to enable or disable synchronization with an NTP server.

    If the application ISO image is deployed on a VMware virtual machine, time synchronization with the hypervisor is automatically disabled if you enable synchronization with an NTP server. If you are using the Hyper-V hypervisor, you can enable or disable time synchronization in virtual machine settings in the SettingsIntegration Service section using the Time Synchronization check box.

  4. If you have enabled synchronization with an NTP server, in the NTP servers field, type the fully qualified domain name (FQDN) or IP address of the NTP server in IPv4 or IPv6 format and press ENTER.

    You can type addresses one by one or paste a whole list of semicolon-separated servers.

  5. Click Save.
  6. Restart all cluster nodes to apply the configuration.

Date and time is configured. The entered changes will be saved on the Control node and will be distributed to all cluster nodes. The time synchronization status will be displayed in the information about each cluster node.

Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.